People can choose between EZGO gas golf carts or electric ones. An EZGO gas golf cart is named as such because it runs on gasoline. A gas golf cart is easier and faster to refuel. This is unlike electric golf carts that need some time to charge. A gas golf cart can pull loads that are heavy. Gas golf carts also have relatively faster speeds. Gas golf carts have more mileage too. On average their fuel tank capacities range between 5 and 6 gallons (19 and 23 liters). Of which as much as 40 miles (64 kilometers) can be covered per gallon. Despite these advantages EZGO gas golf carts can encounter challenges at times. Here is what you must know about troubleshooting EZGO gas golf carts.
Table of Contents
What To Do When An EZGO Gas Golf Cart Will Not Start
It often happens that an EZGO golf cart might fail to start. This can even happen whilst all other things are in order e.g. the starter switch. There are numerous possible reasons that can cause a gas golf cart to not start. The gas line might have been physically damaged somehow. It is advisable to check if the line is in good condition. Gas might not be flowing freely due possibly clogs of dirt. Cleaning the gas line can address that issue. Cleaning the gas line also deals with contamination. That same contamination could have affected the carburettor. Cleaning it will also deal with possible contamination.
Blockage of the air filter can be a possible issue. Either you clean it or even get a new one where need be. Maybe it could be the spark plugs that are dirty, faulty or damaged. Do the needful when you discover what it is. Spark plugs must have certain gaps in between. If those gaps are not properly set, the cart might not start. You must also check coils and valves to see if the wiring is good along with other inspections. Evidently there are a number of checks in EZGO gas golf cart troubleshooting if it is not starting.
EZGO Gas Golf Cart Gas Leakages
You might find that your gas might be usually depleting fast. You could even notice that there is gas coming out of the valve. All of this can point to gas leaking from somewhere. The place to look is usually your carburetor. A faulty injector valve can impede fuel from flowing smoothly. There will be a build-up or the fuel will float and eventually be forced out due to pressure. That is when you can begin to notice gas entering the part of the engine that contains the crankshaft.
Two remedial focuses when troubleshooting the EZGO gas golf cart here are the injector valve and the whole carburettor. You can fix or replace the injector valve. In some cases you might notice anomalies in the carburettor and fix them. When the problem is significant replacing it becomes inevitable. Gas leaks can cause the cart to not start or suddenly stop when you least expect it.
Troubleshooting EZGO Gas Golf Cart Motor Complications
There is a long list of things that can cause the motor to malfunction. The motor might not operate due to the golf cart battery-related problems. It could be that the battery has little to no charge. This could have been caused by the battery not taking up any charge during the last run. When an EZGO gas golf cart will not charge it is best to check the voltage regulator. Several issues tend to occur with the voltage regulator that can stop charging from happening. It can be the wiring which can be loose, physically damaged, or corroded. Sort out any loose connections and remove any dirty present.
If the physical damage is too significant then replace the wiring. Consider using a voltmeter to do some checks on the voltage regulator. The voltage reading will indicate whether or not the voltage regulator is in good working condition. If the reading is off the best thing would be to replace the voltage regulator with a new one. When troubleshooting an EZGO golf cart motor, you can also look at other components. For example, you can inspect the solenoid, fuse, switches (e.g. for ignition and acceleration), coils, and the terminals of the motor itself. Another key thing to check is the electrical conductor connected to the ground. It might be damaged or falling short in terms of its length.
Addressing EZGO Gas Golf Cart Speed Inconsistencies
You might not notice that your cart fails or struggles to accelerate. This can happen yet at slow speeds it might be functioning just fine. When you try to accelerate the cart might begin to jerk indicating some form of resistance. The cause of this issue can be a faulty carburettor; often happens when there is clogging in it. If it is the case then you can clean off the dirt and try again. If that does not address the issue then you would have to check the wiring. Particularly wiring that connects to the speed controller, the accelerator, or in the engine in general. It is the same drill i.e. checking for physical damage, loose connections, or short circuits.
Other possible causes of speed consistencies especially at high speeds could be the float settings of the carburettor. If those settings are erroneous, engaging into high speeds might be problematic. Simply correct them to fix the issue. It could possibly be that the air filter is blocked. Cleaning the filter would be the remedy here. Cleaning is applicable to a number of troubleshooting efforts actually. For instance, it is obvious dirt tends to build up over time. The brakes could also be faulty. In general, you can note several issues of concern by troubleshooting the engine as whole. Conduct checks on it and you will realize there might be need for service or some repair work.
Those are the key areas to focus on when troubleshooting an EZGO gas golf cart. EZGO gas golf troubleshooting should not be rocket science per se. Just simply follow this protocol or approach: check or inspect, fix or repair, and clean or replace.